Idiomas disponibles
Idiomas disponibles
MIG welding torch switch (Effective only in MIG mode):The welding machine only be operated with the Spool gun torch in the Spool gun torch mode; The
3
MIG gun only be used for welding in the MIG gun mode.Please check the switch status when using.
4
Mode switch:MIG /MMA /LIFT-TIG functions. In MIG Mode, the button [3]is valid.
2T/4T switch.
5
2T is manual, that is, always press the switch for welding
4T is semi-automatic, that is, pressing is arc striking, loosening is automatic welding, and then pressing is arc stopping
ADJUST VOLTAGE:Adjustment is only effective in MIG mode, not available in MMA, lift and TIG modes.[2] is no change when adjusting the voltage.You
6
can get very good welding results when pointing the current[7] voltage[6] knob to the same scale
ADJUST CURRENT: [1] is no change when adjusting the voltage.You can get very good welding results when pointing the current[7] voltage[6] knob to
7
the same scale
3.2 Welding operation instruction
On display
After open the power supply,Current display is 000,Voltage display is 000 in the MIG mode,Voltage display is no-load voltage in lift TIG and MMA modes.
The actual output current and voltage are displayed only during the machine working.
MMA Manual welding operation procedures
There are two ways to connect the dc welder normally:
Positive connection ： Welding pliers connected to the negative pole, workpiece connected to positive pole. Suitable for
acid electrode.
negative connection: workpiece connected to the negative pole, Welding pliers connected to the positive pole. Suitable
for basic electrode.
The welding function is selected according to the welding process requirements of the workpiece, incorrect data
adjustment may cause arc instability, spatter and adhesion occur, we can change the polarity joint for different
workpiece as above.
Make sure the cable is connected to the soldering pliers and the quick plug,Connect the quick plug to the corresponding fast socket ， And tighten it
clockwise. The ground clamp clamps the workpiece.
When the welding stop, operation [manual welding and gas protection welding switch key], Manual welding indicator light, into manual welding mode.
In Manual welding mode, adjust 【 Multifunctional data adjusting knob 】 The welding current can be changed, in 【 Multifunctional data display window 】 display.
The welding current range is 40A to maximum current 150A adjustment.
Operating procedures for MIG -
gas protection welding-
Solid Wire
Welding wire Installation. (Refer to 3.1)
Please choose wire feed roller.V roller for stainless steel and carbon steel.
Connected with The gas cylinder. (Refer to 3.3)
insert the fast plug of the ground wire in the front panel on the fast socket.
Check wire operation ： press torch switch, the wire feeder will feed the wire through the torch tip.
Select MIG mode on the front control panel(Make sure you are not in SPOOL GUN state).
select the right material and diameter you are welding with. Adjust current according your workpiece
thickness.
To find the best welding performance and suitable for your welding habits. You may also adjust voltage and inductance to build a perfect welding bead and
penetration.
Gasless welding-
flux cored wire
Welding wire Installation. (Refer to 2.1)
Please choose wire feed roller. Knurled roller for flux cored wire.
insert the fast plug of the ground wire in the front panel on the fast socket.
Check wire operation ： press torch switch, the wire feeder will feed the wire through the torch tip.
Select MIG mode on the front control panel(Make sure you are not in SPOOL GUN state). After that, select the
After that,
34
