Idiomas disponibles
Idiomas disponibles
3. INSTALLATION METHOD
4. Wire controller upper part Remove
Insert a flat screwdriver into the
slots in the lower part of the wire
controller (2 places).
Remove the upper part of the wire
controller (Fig.3-4)
NOTE: The PCB is mounted in the
upper part of the wired controller. Be
careful not to damage the board with
the screwdriver.
5. Fasten the wire controller back plate
For surface mounting, fasten the back plate on the
wall with the 3 screws (M4x20) and plugs. (Fig.3-5)
Screws (M4×20)
Back plate
Fig 3-5
8
Slots
Fig 3-4
V.1
