Idiomas disponibles
Idiomas disponibles
SAFETY RELEASE BAR IN LOCKED AND READY TO FIRE POSITION
The safety release bar and faceplate must always be in the locked position prior
to firing the UC-HL2 Launcher. (Fig #7) Failure to secure faceplate and safety
release bar in the locked position may cause serious injury to the operator
and or damage to the launcher
OPERATION
Place the hose, tube or pipe against the nozzle to insure a good air tight seal.
(Fig #8) Be sure the hose, tube or pipe is clear and free of internal blockages,
clogs and obstructions.
Depress the trigger. Keep the trigger depressed until the projectile exits the hose,
tube or pipe that you are cleaning.
MAINTENANCE AND REPAIR - PROBLEMSOLVING
The UC-HL2 Launcher is designed for long -life use. To be sure that the
launcher can be operated without risks, carry out simple inspection and
cleaning before use.
Inspection list
Be sure the air source is disconnected from the launcher
-
Check the safety release bar
with opened faceplate
-
Check the faceplate
-
Check the trigger
-
Clean the faceplate and the
surface of the rotary plug
In case of detection of any kind of failure, contact your supplier. Do not
make any modifications to the launcher.
Garantuee is not applicable in any case of modification by other persons
than persons authorized by Ultra Clean Technologies Corp.
The release bar should move smoothly
back and forth
No visual damages or wear
The faceplate should move smoothly back
and forth
No visual damages
The trigger should operate with only light
fingerpressure and always return after
depressing
Use a piece of clothe to remove any dust
or moist
