Star Progetti ECO FRESH AIR FRE5001 Manual De Instrucciones página 26

Idiomas disponibles

Idiomas disponibles

PLEASE READ THE MANUAL CAREFULLY BEFORE OPERATING THE COOLER.
A) Operating conditions:
1- Temperature: 18℃ to 45℃; Water Temperature: < 45℃.
2- Power supply must not exceed the required voltage (+/-) 5%.
3- Air supply must be largely free of dust or extra cleaning is required.
B) Protect the power cable from vehicle or foot traffic. Connection to incorrect electric voltage, or faulty
installation, will cause danger of electric shock.
C) If the product malfunctions at startup, please disconnect from electric power immediately and refer to dealer
for service.
D) Other tips for cooler use:
1- Keep doors and windows open to allow fresh air to enter, and treated air to exit, when cooler is operating.
2- An audible signal indicates that the water level in the tank is low.
3- Rinse the reservoir with fresh water and clean prior to use after a period where the cooler has not been in
operation.
4- Take care when moving the cooler, especially when it is full of water. Pushing too hard will cause the cooler
to overbalance and tip over, which may cause injury and will damage the cooler.
MAINTENANCE
For best results and long term operation, regular maintenance is essential.
To ensure the cooler delivers fresh and clean air, regularly change the water when dirty, and clean both the
dust filter and the cooling pad.
1) Remove the filter pad by unscrewing the screws on the rear of the cooler, then lift the pad and pull out at
the bottom to release. To replace the pad, slide up into the slot under the top of the cooler, push in at the
bottom and allow to drop into the lower slot.
2) Clean the pad from the inner-side to out-side of pad (inner side is towards motor). Never use any
liquid detergent. Never use pressurized water, as it may cause damage to the pad.
3) Unscrew the drainage lid to let dirty water flow out, then clean the water tank thoroughly with a soft cloth.
Wash off dirt on the water sensor, water pump and the float valve. Rinse thoroughly.
4) Use mild soap and soft clean cloth when cleaning the cooler casing. Do not use any caustic chemical
detergent that may cause damage to the surface of the cooler.
26
loading