Idiomas disponibles
Idiomas disponibles
How to Use
EN
6. Spot Clean Mode
When the robot is paused or in Standby Mode, press and hold
the button
for 3 seconds to start Spot Clean Mode. In this
mode, it will clean a square-shaped area of 1.5 ×1.5 meters
directly around the robot. When the spot cleaning is done,
the robot will automatically return to its original location and
power off.
1.5 meter
1.5 meter
Note: When the robot is paused, activating Spot Clean Mode will end the current
cleaning task.
12
7. Scheduled Cleaning
You can schedule cleaning time in the app. The robot will
automatically start cleaning at the designated time and then
return to the charging dock to recharge when the cleaning is
done.
8. Additional App Functions
Follow the instructions on the app interface to use more
functions. The version of the app might have been updated;
please follow the instructions based on the current app version.
How to Use
9. Use the Mopping Function
It is recommended that all floors are vacuumed at least three
times before the first mopping session to achieve a better
cleaning effect.
1) Dampen the mop pad, wring out excess water, and stick
them onto the mop pad holder firmly. Then install the mopping
module on the robot.
2) Remove the water tank and fill it with water as shown in the
figure, then put it back into place.
Note:
· Do not fill with hot water, which may cause distortion of the water tank.
· Do not expose the tank to the sun directly.
· If slow water flow occurs, or the outflow is not well-distributed, please clean the
air hole in the tank.
3) Press the button
or use the app to start cleaning.
Note:
· It is not recommended to use the mopping function on carpets.
· Use the app to adjust the water flow as required.
4) After cleaning task is done, remove the mop pad as shown
in the diagram. To remove the water tank, press and hold the
release clip on both sides, and drag them upward.
Note: When the robot is charging or not in use, remove the mopping module, pour
out all the remaining water in the tank, and clean the mop pad to prevent mildew
or odor.
EN
13
