Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problemswith the assemblyof your
pressurewasher, please call the pressurewasher heipline
at 1-800-222-3135.
Attach Handle
1.
Placehandle (A) onto base (B). Make sure holes in
handle align with holes on base.
UNPACKTHE PRESSURE WASHER
1.
Remove everything from carton except pressure washer.
2.
Open carton completely by cutting each corner from top
to bottom.
3.
Remove pressure washer from carton.
CARTONCONTENTS
Checkall contents, if any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
•
Main Unit
•
Handle
•
Wheel Kit
•
High Pressure Hose
•
Spray Gun
•
Adjustable Nozzle Extension
•
Oil Bottle
•
Parts Bag (which includes the following):
•
Operator's Manual
•
Owner's Registration Card
•
Safety Goggles
•
Mesh Accessory Bag
Becomefamiliar with each piece before assembling the
pressure washer, identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1.
Fill out and send in registration card.
2.
Attach handle to main unit.
3.
Install wheel kit.
4.
Add oil to engine crankcase.
5.
Add fuel to fuel tank.
6.
Connect pressure hose to spray gun and pump.
7.
Connect water supply to pump.
8.
Attach nozzle extension to spray gun.
2.
Insert carriage bolts (C) through holes from outside of
unit and attach a plastic knob (D) from inside of unit.
Tighten by hand.
Install Wheel Kit
The wheel kit is designed to greatly improve the portability of
your pressure washer.
NOTE:Wheel kit is not intended for over-the-road use.
install the wheel kit as fellows:
1.
Placethe bottom of the pressure washer frame on a flat,
even surface.
2.
Slide a wheel (A) over the axle pin (B).
NOTE:Be sure to install wheel with raised hub inboard.
3.
Slide axle pin through hole (C) in frame.
4.
Retain wheel on axle pin with retaining pin (D).
5.
Repeatstep 2 through 4 to secure second wheel.
Tabla de contenido
