Efapel D40 Manual De Instrucciones página 14

ADDING DEVICES TO THE NETWORK
1 STEP
ST
Press RESET 7 seconds
until all the LEDs are
at half brightness.
2 STEP
ND
Click on PROG.
3 STEP
RD
Click on the command
button of the Installa-
tion Key (Ref. 40925)
in close proximity to
the device.
14
1.1 - The LED ON
switches on.
2.1 - The LED ON starts
to blink, indicating that
it is ready to be added
to the network, during a
period of 10 seconds .
3.1 - The red LED starts
to blink, indicating that it
is searching for the device
that is going to be added.
3.2 - The green LED blinks
and switches off, the de-
vice's LED ON switches
off and the A, B, D, C
LEDs switch on and off in
sequence, indicating that
the Switch was successfully
added to the network.
Note: If the Installation Key LED
does not turn green and switch
off, repeat from the 1st step.