Idiomas disponibles
Idiomas disponibles
ASSEmBLy
Warnings
• Bracket must be installed so that Boguard's electronic equipment is vertical
(Fig. A) and the electrical connections are facing downwards (Fig. E)
• The immersed part of the electrode must not come into contact with parts mounted
on the tank and/or with the wall of the tank itself. The electrode's rod must not be
subject to abrasion.
• After mounting the plug, check the insulation (Fig. B) and continuity (Fig. C) with an
electric tester.
– The electrode's central titanium rod must be fully insulated from the plug.
– The plug's thread must have electrical continuity with the storage tank's metal
surface.
Procedure
• Place the Teflon strap on the plug's thread 9 to ensure it is watertight.
• Insert the electrode in the tank's special threaded sleeve and make sure you screw
it on tightly.
• Remove the protective cap from the bracket.
• Secure the bracket to the insulating casing with the screws and double-sided adhe-
sive tape supplied or near the tank on one of the room's walls with wall plugs (not
supplied) by taking into account the cables' length.
• Insert the cap into place . The cap must be placed in the connection hole of the
cable whenever the cable itself is disconnected.
• Secure Boguard's electronic device to the bracket.
• Connect the cable to the device and the electrode(s) and lock it into place on the
upper part of the bracket (Fig. E).
CAution
Do not cut or modify the cables.
gB
13
