TREVIDEA Girmi RC15 Manual De Instrucciones página 11

Idiomas disponibles
  • ES

Idiomas disponibles

DESCRIPTION RC15
1. Blade
5. Charging light
8. USB cable
OPERATING
The hair clipper can be used both weather it is connected with the USB cable or not.
WARNING: if during battery working the appliance stop working, put switch (4) in OFF position, connect
USB cable (8) to a proper USB charger and to connector (6). Wait one minute before starting again operation.
HOW TO USE
- Keeping off the unit, mount the supplied comb (7). Choose the length of cut you wish to obtain with the
regulator (3) (from 1 to 10 mm). Turn on the clipper with the ON/OFF button (4) and start cutting.
- Once finished cutting operation, turn off the device using the power button (4), remove the comb and store
the clipper and its accessories out of the reach of children.
RECHARGING
When you first use the product fully charge it, leaving it connected for at least 1.5 hours.
To recharge, connect the USB cable (8) to a suitable USB socket (PC, USB charger, power bank....) and into
the connector on the rear of product (6).
During charging the LED (5) is red. When battery is fully charged, it becomes green.
The following measures will preserve the battery life.
At first use the product fully charge the product, leaving it connected for at least 1.5 hours. Before you
recharge, completely discharge the battery.
When the unit is not in use for a long period (2 months), it is recommended to let it charge for about 1.5 hours
before using. In any case it is advisable to fully discharge the battery before recharging. If the appliance, even
after a recharge, works only if it is connected to the USB, it is possible that the battery is no longer capable of
delivering enough power to the unit. In this case, please contact an authorized service center.
MAINTENANCE AND CLEANING
After each cut, always clean used comb (7) and cutting blade (1) by blowing over them or
using the small brush (9). Periodically lubricate the blade by following the steps below.
Extract the blade set (2) by pulling it up as shown in figure. Remove remaining hair by
blowing or using the small brush (9).
Use lubricating oil (10) for the blade. 2 or 3 drops are enough if this operation is carried
out frequently. Two points must be lubricated with oil: Put 1-2 drops on the blade. Put 1-2 drops on the
driveshaft joint. Use only the provided oil or similar oil without acids.
Clean the main body by using a soft damp cloth, never immerse the unit in water or other liquids.
TECHNICAL FEATURES
Input 5V – 1000mA
Charging light - Cutting height adjustment
Litium battery, 600mAh, with fast 1.5 hours, lasting 60 minutes
Accessories: separating comb, USB cable, lubricating oil, small brush
PORTUGUÊS: ADVERTÊNCIAS
As indicações seguintes são muito importantes no que se
refere à instalação, uso e manutenção deste aparelho;
conserve com cuidado este manual para eventuais
2. Removable blade set
6. Charging input
9. Small brush
3. Cutting regulator
7. Separating comb
10. Lubricating oil
4. On/off button
10
loading

Este manual también es adecuado para:

Rfc-1903