Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4. OPERATION INSTRUCTIONS
•
The Beamer 230 is for beam effect for on-site
decoration purpose.
•
Don't turn on the fixture if it's been through
severe temperature difference like after
transportation because it might damage the
light due to the environment changes. So make
sure to operate the fixture until it is in normal
temperature.
•
This light should be keep away from strong
shaking during any transportation or
movement.
•
Don't pull up the light by only the head, or it
might cause damages to themechanical parts.
•
Don't expose the fixture in overheat, moisture
or environment with too much dust when
installing it. And don't lay any power cables on
the floor. Or it might cause electronic shock to
the people.
•
Make sure the installation place is in good
5. INSTALLATIONS
Cautions: For added protection mount the fixtures
in areas outside walking paths, seating areas,
or in areas were the fixture might be reached by
unauthorized personnel.
Before mounting the fixture to any surface, make
sure that the installation area can hold a minimum
point load of 10 times the device's weight.
Fixture installation must always be secured
with a secondary safety attachment, such as an
appropriate safety cable.
Never stand directly below the device when
mounting, removing, or servicing the fixture.
from a ceiling, or set on a flat level surface (see
illustration below). Be sure this fixture is kept
at least 0.5m (1.5 ft) away from any flammable
safety condition before installing thefixture.
•
Make sure to put the safety chain and check
whether the screws are screwed properly when
installing the fixture.
•
Make sure the lens are in good condition. It's
recommended to replace the units if there are
any damages or severe scratch.
•
Make sure the fixture is operated by qualified
personnel who knows the fixture before using.
•
Keep the original packages if any second
shipment is needed.
•
Don't try to change the fixtures without
any instruction by the manufacturer or the
appointed repairing agencies.
•
It is not in warranty range if there are any
malfunctions from not following theuser
manual to operate or any illegal operation,
like shock short circuit, electronic shock, lamp
broke, etc.
materials (decoration etc.).
Always use and install the supplied safety cable as a
safety measure to prevent accidental damage and/
or injury in the event the clamp fails.
Mounting points: Overhead mounting requires
extensive experience, including
amongst others calculating working load limits,
a fine knowledge of the installation material
being used, and periodic safety inspection of all
installation material and the fixture. If you lack
these qualifications, do not attempt the installation
yourself. Improper installation can result in
bodily injury. Be sure to complete all rigging and
installation procedures before connecting the main
| Tecshow Beamer 230
English version
P. 5
Tabla de contenido
