Idiomas disponibles
Idiomas disponibles
Mounting kit 76596TL
1.2
English
1.2.1
Mount frame bracket
1. Mount frame bracket for assembly kit in existing hole on the inside of the truck's chassis. Use 4. M12x110
(70-75 Nm).
2. Enlarge holes on the inside of the vehicle's frame to Ø15mm, so that the spacer can go through.
Use 1. M10x90 (40-45 Nm), nut, washer and a spacer.
1.2.2
Attaching the mounting jig to the rear beam
1. Measure and mark the midpoint of the vehicle's rear beam.
2. Check the A measure, if cut outs need to be done in the rear beam, see marking Image 3.
3. Do the necessary cut outs from the rear beam according to the illustrations with the installation dimen-
sions for the respective lift model.
4. Attach the mounting rig to the rear beam so that the respective midpoint corresponds. Use clamps,
screws or spot weld.
Image 1.
Image 3.
6
Z3N/Z3NU, Z3NN/Z3NNU, Z3NW/Z3NWU 75-100
Image 2.
Image 4.
Ø15mm
www.zepro.com
