Epson TM-P60II Manual Del Usuario página 10

English
Battery LED (White)
Printer Condition
Power On
Power on and
buzzer sounds.
*You can select whether to continue printing or to stop printing when only1 LED flashes.
(Power) button
Press this button to turn the power on or off. To turn the power off, hold the
button for more than 2 seconds.
Feed button
Press this button to feed paper.
Installing and Charging Battery
Follow the steps below to install and charge the battery.
Note:
The battery can be charged only when the temperature is 0 ~ 40°C {32 ~ 104°F}.
1. Make sure that the printer is turned off.
2. Slide the battery cover (B 11) to open it.
Install the battery (B 12), and close the battery cover.
3.
4. Connect the AC adapter to the printer. See illustration C for the connecor.
Recharging starts.
Notes:
Recharging will take approximately 3 hours with the AC adapter or with the optional
battery charger OT-CH60II. For detailed information on the battery charger, see its user's
manual. The time described above is the time required to charge a battery pack that is fully
discharged.
Recharging the battery at 35
the printer, which may reqire a longer charging time than the specified one. The Charge
LED flashes while charging the battery.
Installing or Replacing Roll Paper
Follow the steps below and see illustration D to install or replace the roll paper.
CAUTION:
Be sure to use roll paper that meets the specifications.
Note:
Do not use the roll paper that have the paper glued to the core.
1. Press the open button to open the roll paper cover.
2. Remove the used roll paper core if there is one, and insert the new roll paper.
Note:
Note the direction the paper comes off the roll.
6 TM-P60II User's Manual
Battery Error Battery
LED charge status
LED
3 LEDs On Off Level H
2 LEDs On Off Level M
1 LED On Off Level L
1 LED Off Level S *
flashing
On
3 LEDs Off On Level E
C {95°F} or higher activates the internal temperature control of
°
Meanings
You can continue printing, but
replacement or charge of the
battery is recommended.
Replace or charge the battery.
(Printing may stop in the middle.)
Replace or charge the battery.
(The printer is unable to print.)
Replace or charge the battery.