NORAUTO 2372772 Manual página 70

Retrieve I / M ready state
EN
l/M ready function is used to check the operating situation of
vehicle emission system that is accorded with OBD2 standard.
This is a very good function before checking if the vehicle is
accorded with the state emission plan. Some newest vehicles
models may support two types of l/M ready test:
A. DTC has been deleted - Shows the display status since DTC
has been deleted.
B. This Drive Cycle - Shows the monitor status since the current
drive cycle has been started. l/M ready result is "No", it is not
sure shows the tested vehicle can not pass the state l/M
check. Some states permit one or multiple such monitors are
"Non-ready" passed the emission check.
 "Confirm" - Shows the diagnostic test for the special monitor
being checked has been finished.
 "INC" - Shows the diagnostic test for the special monitor being
checked has not been finished.
 "Not applicable" - The vehicle doesn't support the monitor.
1 Press Up/Down button to select l/M ready from Diagnostic
menu, and then press Return/Confirm button.
Read Codes
Erase Codes
l/M Readiness
Data Stream
Freeze Frame
Voltage test
Vehicle Information
• If multiple modules are detected, the system will prompt you to
select the module before testing.
• Press Up/Down button to select a module, and then press
Return/Confirm button.
2 Wait a few seconds until the reader PID mapping is verified if
the vehicle supports two types of tests. Display two types on
the screen to choose from
Since DTCs Were Cleared
Press Up/Down button to read MIL Iight status ("ON" or "OFF")
and the following monitors: Press Up/Down button to read MIL
Iight ("ON" or "OFF") and the status of the following monitors:
• Misfire monitor -- Misfire monitor
• Fuel System Mon -- Fuel system monitor
• Component -- Comprehensive component monitor
• EGR -- EGR system monitor
• Oxygen Sens Mon -- Oxygen sensor monitor
• Catalyst Mon -- Catalyst monitor
69
Diagnostic Menu
l/M Readiness