Stealth Products MTHW-620 Manual De Usuario página 7

Removable Mount Installation
Applies to the following hardware:
MTHW-600
Figure A: The two screws are guides for the support.
Figure B: The center hole is larger than the other two.
Figure C: Turn the knob counter-clockwise to remove the
medial thigh support. Turn clockwise to tighten.
NOTICE
EN
MTHW-610
Mounting the removable hardware:
1. Locate the center row of t-nuts
in the bottom of the seat. Insert the
two 1/4-20 x 1/2" Socket Head
Screws into the front and rear holes
(Fig. A) and tighten with a 3/16" hex
key (these screws are only to
prevent rotation of the bracket).
Leave the center hole open for the
installation of the knob in the next
step.
2. Thread the 3/8-16 x 1 1/2"
Socket Head Screw into the knob if
it is not already threaded into it.
Twist it until it is about half way
through the knob.
3. Apply red threadlocker to 4-5
threads at the tip of the 3/8-16 x 1
1/2" Socket Head Screw (knob),
and thread it loosely into the t-nut
in the seat. Allow enough room
between the base of the knob and
the seat for the support bracket to
slide easily. Make sure there is no
excess threadlocker on the screw or
knob and allow it to cure according
to the directions on the package.
Once cured, slide the support
bracket into position and lock it in
place
clockwise. (Fig. C)
Be sure not to overtighten screws.
MTHW-630
by turning the
Installation
knob
2