Phottix Mitros TTL Manual De Instrucciones página 12

Quick Flash Function
The Quick Flash function allows the flash to fire at 1/6 to 1/2 of the full output.
Flash recycle times are faster. This is best used for close subjects in situation
where photos need to be taken quickly.
Quick flash can be used with continuous drive modes, Quick Flash for continu-
ous shot function can be enabled or disabled (see C.Fn 06 above).
Please note:
The Quick Flash Function makes flash firing a priority. Under-exposure can
result if the subject is located too far from the camera or if photos are taken
too quickly.
Auto Backlight
By default, pressing any button on the Mitros flash will cause the LCD backlight
to illuminate. The backlight will illuminate for 8 seconds and turn off if no but-
tons are pressed.
This function can be disabled though C.Fn 14. If disabled, pressing the
ton only will illuminate the LCD backlight.
Slave Flash Beep Confirm
When the flash is used as a wireless slave it will beep twice when an optical
signal is received from the Master Flash. This can be disabled (see C.Fn 04 above)
Button Beep Confirm
Using the Phottix Mitros buttons provides audible feedback – beeps – when
each is pressed. This function can be turned off (see C.Fn 13 above)
TTL Pref
TTL may vary slightly when using the flash on different cameras. TTL Pref (C.Fn
15) setting allows users to adjust EV from +3 to -3 in 1/3rd stops to compensate
for these slight variations. This adjustment is a personal preference based on
camera standard TTL and will be stored in memory. When this EV level prefer-
ence is set, this compensation will be used for images taken in TTL mode. This EV
compensation will not be displayed on the LCD during regular use.
Resetting to Factory Defaults
The Phottix Mitros Flash can be reset to factory defaults.
To reset the flash:
1. Press and hold the and
2. The flash will reset to factory default settings.
3. All custom functions will be reset to factory defaults.
12
buttons for 3 seconds.
En
Flash Information Display
For technical support or firmware upgrade checking the Phottix Mitros informa-
tion may be needed. To display the hardware, software, icon library and serial
number display:
1. Press and hold the
2. Press any button to cancel this display and enter the LCD screen.
Changes to the flash capacitor:
If the flash is not used for some time physical changes will take place within the
flash's capacitor. Make sure to turn on the flash a minimum of 10 minutes every
three months to prevent any physical changes.
but-
INSTRUCTION MANUAL
button, and then turn on the flash.