Idiomas disponibles
Idiomas disponibles
Problem
Possible Cause
The under-thread
The under-thread bobbin is not inserted
breaks.
correctly.
The upper-thread tension is too loose.
Stitches are skipped.
The needle is not inserted correctly.
The needle is damaged.
The wrong needle size has been used.
The presser foot is not attached correctly.
The needle breaks.
The needle was damaged.
The needle is not inserted correctly.
Wrong needle size for the fabric.
The presser foot is not attached correctly.
Loose stitches
The upper-thread is not threaded correctly
in the sewing machine.
The under-thread bobbin is not inserted
correctly.
Needle / fabric / thread combination is
wrong.
Wrong thread tension.
Seam curls
The needle is too big for the fabric.
The stitch length is set incorrectly.
The thread tension is too tight.
Technical Data
Model:.................................................................NM 6063 CB
Protection class: ..................................................................
Power supply:...............................................DC 6 V, 1200 mA
Sewing field light: ............................................LED 0.1 W, 3 V
Net weight: ....................................................... approx. 2.1 kg
Power Supply Unit
Protection class: ...................................................................
Input: ........................... AC 100 – 240 V, 50 / 60 Hz, max. 0.4 A
Output:..........................................................DC 6 V, 1200 mA
Polarity: ......................................................................
Battery operation: ............................. 4 × 1.5 V type AA / LR6
The right to make technical and design modifications in the
course of continuous product development remains reserved.
This appliance has been tested according to all applicable,
current CE directives and built according to the latest safety
regulations.
16
NM6063CB_IM
Remedy
Check the position of the under-thread bobbin.
Adjust the upper-thread tension (higher number).
Remove the needle and reinsert it. (Flat side of the
needle points to the back).
Insert a new needle.
Choose a needle that is suitable for the thread and
fabric.
Check the position of the presser foot and insert it
correctly.
Insert a new needle.
Remove the needle and reinsert it. (Flat side of the
needle points to the back).
Choose a needle that is suitable for the thread and
fabric.
Check the position of the presser foot and insert it
correctly.
Check the threading of the upper-thread.
Insert the under-thread bobbin correctly.
The needle size must be suitable for fabric and
thread (see table on page 13).
Correct the thread tension.
Select a finer needle.
Select a suitable stitch pattern with the stitch pattern
adjustment wheel.
Loosen the thread tension (lower number).
Product Specifications in Accordance with
Regulation (EU) 2019 / 1782 Power Supplies
Information about the
Power Supply Used
Distributor
C. Bomann GmbH
Commercial register number HRB 9845
Heinrich-Horten-Straße 17, 47906 Kempen
Germany
Model identifier
Input voltage
Input alternating current
frequency
Output voltage AC / DC
Output current
Value
Unit
SW0601200-W02
100 – 240 V~
50 / 60 Hz
6.0 V DC
1.2 A
19.04.23
