Idiomas disponibles
Idiomas disponibles
USER GUIDE
IMPORTANT NOTES
►
You MUST have your existing key that already works with your vehicle
in order to use the EZ Installer™. If you have no working keys, return the
entire product to the retailer where it was purchased.
►
All existing, working remotes must be present during the pairing
process. Once you pair a new remote, all previous remotes will be
erased from the memory. The others will not be functional until you pair
them again.
►
Vehicle battery should be in good condition and fully charged prior
to pairing the new remote. Turn off headlights, radio, A/C fan, etc. to
minimize battery draw during the process.
►
Do not use the EZ Installer while the vehicle is in motion. Unplug it
from the OBD port before driving the vehicle.
►
Only original remote features will work, regardless of buttons included
in this package. This remote does not add features your vehicle did not
have before.
►
For your security, a tamper-evident security label is installed over the
EZ Installer connector. If this label is missing, damaged, or the word
"VOID" appears on the EZ Installer, please exchange this product for a
new one at the retailer where it was purchased.
►
Before pairing, familiarize yourself with the remote's compatibility with
the make, model, and year of your vehicle on page 3.
LET'S GET STARTED
This product requires PAIRING. It's important to follow these steps in
order to successfully complete setup.
If you skip a step, the remote WILL NOT work properly, and you'll have
to repeat the setup process.
Find your PRIMARY DIAL POSITION in the following chart by
referencing your vehicle's make, model, and year.
2
USER GUIDE
COMPATIBILITY LOOKUP
MAKE/MODEL
YEARS
CHEVROLET
Colorado
2015-2020
Silverado
2014-2018
Suburban
2015-2020
Tahoe
2015-2020
GMC
Canyon
2015-2020
Sierra
2014-2018
Yukon
2015-2020
Visit CKESimpleKey.com for the most up-to-date vehicle compatibility list.
REMOTE PAIRING INSTRUCTIONS
Instructions have timing requirements. If you wait too long between steps, your
vehicle's computer may time out, requiring you to start over. Once you begin
the pairing procedure, move at a quick and even pace.
NOTE: If the EZ Installer is left in the vehicle's on-board diagnostic (OBD) port
for more than 5 minutes, an alarm will sound reminding you to remove it.
NOTE: If at any point the EZ Installer continues to beep rapidly, please refer to
the FAQ section for more information..
NOTE: This procedure will erase all old remotes when starting the
programming procedure. You MUST have all existing remotes present during
the programming process. Remotes can be added at any time using the EZ
Installer, but each time it is used the remote memory will be erased. You may
add up to 4 total remotes during this procedure.
PRIMARY
DIAL POSITION
2
2
2
2
2
2
2
3
