Idiomas disponibles
Idiomas disponibles
Introduction
The echo and roger beep module PNI ECH01 is designed to work together
with any CB and VHF/UHF transceiver as an additional module, having as
main functions:
•
Generating the echo effect of the signal captured by the transceiver's
microphone and inserting it in the modulation level;
•
Generating a custom signal (MP3 audio file) at the end of the transmission
and maintaining it.
Technical specifications
•
Supply voltage: 9 - 12V
•
Idle current: 6 mA
•
Operating current: 56 mA
•
Distortion ~ 3.72% (depending on microphone capsule)
•
Supported files: MP3, WAV
•
Audio file length: 1.5 sec. (firmware V1.0)
Copy MP3 file to Echo and Roger Beep module
Copy an MP3 / WAV file to the Echo and Roger Beep module following the
steps below:
1. With the module already connected to the transceiver according to the
connection diagrams shown below:
•
Turn on the radio station.
•
Move the switch to the Open position.
•
Connect a USB - Micro USB data cable between the PC (laptop) and the
echo module.
•
Delete the existing file and copy the new file.
•
To disconnect, safely remove the storage media from the operating system
("Eject" or "Safely remove mass storage").
•
Disconnect the USB cable - Micro USB.
•
Move the switch to the Close position.
Caution: Do not transmit with the transceiver while the module is connected
3
User manual
