Chicago Pneumatic Battery Pack 18V 2.5 Ah Manual De Instrucciones página 6

Operation
Operation
Operating Instructions
How to use the battery pack
NOTICE Usage recommendations for battery packs
Ensure a longer service life of the battery pack.
Unplug the battery pack when the tool is not used.
►
Do not leave the battery pack on the charger when the charger power supply is off.
WARNING Only use or store the battery pack in an ambient temperature interval stated in chapter
Technical data.
Initial start
On delivery, the battery pack is in Deep sleep mode.
Use the battery pack charger to charge the battery pack before using it.
How to charge the battery pack
Attach the battery pack to the charger, slide it into position.
To get more information on the battery pack charger, refer to the Product Instructions (printed matter:
8940176811) available at www.etools.cp.com.
To remove the battery pack from the charger, slide the battery pack out from the holder.
How to read the State Of Charge (SOC)
The State Of Charge (SOC) is the level of charge of the battery pack relative to its capacity.
Press button (1) briefly (less than 3 seconds).
Level in %
0-10
11-24
25-49
50-75
76-100
How to check the State Of Health (SOH)
The State Of Health (SOH) measures the condition of the battery pack compared to its ideal conditions.
It enables to know if the battery pack should be replaced or not.
Press button (1) during more than 3 seconds.
Level in %
0-10
11-24
25-49
50-75
76-100
6
LED 1 LED 2
Flashing -
ON Flashing
ON ON
ON ON
ON ON
LED 1 LED 2
Flashing -
ON Flashing
ON ON
ON ON
ON ON
© Chicago Pneumatic - 8940176810
EN
LED 3
-
-
Flashing
ON
ON
LED 3
-
-
Flashing
ON
ON
Battery Pack
LED 4
-
-
-
Flashing
ON
LED 4
-
-
-
Flashing
ON