Idiomas disponibles
Idiomas disponibles
ELECTROMAGNETIC EMISSIONS
This equipment is intended for use in the electromagnetic environment specified below. The
user of this equipment should assure that it is used in such an environment.
Emissions
RF emissions
(CISPR 11)
CISPR emissions
classification
Harmonic emissions
(IEC 61000-3-2)
Voltage fluctuations/
flicker (IEC 61000-3-3)
ELECTROMAGNETIC IMMUNITY
This equipment is intended for use in the electromagnetic environment specified below. The
user of this equipment should assure that it is used in such an environment.
Immunity
Against
Electrostatic
discharge,
ESD (IEC
61000-4-2)
Electrical fast
transients/
bursts (IEC
61000-4-4)
RF Proximity
(IEC 61000-
4-3)
Surges on
AC mains
lines (IEC
61000-4-5)
Compliance
According
To
Group 1
Class B
Class A
Complies
IEC 60601-1-2 Test
Level
Contact Discharge:
± 8 kV
Air Discharge: ±
15 kV
Power Supply Lines:
± 2 kV Input DC
Power Ports ± 2 kV
Signal Input/Output
Lines: ± 1 kV
385 Pulse
Modulation, 18
Hz 450 FM + 5Hz
deviation: 1 kHz sine
710 745 780 Pulse
Modulation: 217 Hz
810 870 930 Pulse
Modulation: 18 Hz
1720 1845 1970
Pulse Modulation:
217 Hz 2450 Pulse
Modulation: 217 Hz
5240 5500 5785
Pulse Modulation:
217 Hz
Common Mode:
± 2 kV
Differential Mode:
± 1 kV
Electromagnetic Environment
The equipment uses RF energy only for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interference in nearby electronic equipment.
The equipment is suitable for use in all
establishments, including domestic
establishments and those directly connected
to the public low-voltage power supply network
that supplies buildings used for domestic
purposes.
Compliance
Level (of
Electromagnetic Environment
this control
unit)
± 8 kV ± 15 kV
Floors should be wood,
concrete, or ceramic tile.
If floors are covered with
synthetic material, the relative
humidity should be kept at
levels to reduce electrostatic
charge to suitable levels.
± 2 kV ± 2 kV
Mains power quality should be
± 1 kV
that of a typical commercial or
hospital environment.
27 V/m 28 V/m
Equipment with high RF
9 V/m 28 V/m
emissions should be kept
28 V/m 28
at a distance to reduce the
V/m 9 V/m
likelihood of interference.
± 2 kV
Mains power quality should be
± 1 kV
that of a typical commercial or
hospital environment.
