Indel B BREEZE T30 Instrucciones De Uso página 15

TEMPERATURE SETTING
The knob for the temperature adjusting thermostat is located in the upper part of the internal liner
of the refrigerator.
To set the internal temperature, adjust the control knob according to the ambient temperature or
based on the use the refrigerator is intended to.
The temperature control range is comprised of the following levels:
• position 0 = refrigerator off
• position 1 = minimal refrigeration (higher internal temperature)
• position 2 = medium refrigeration (intermediate internal temperature)
• position 3 = maximum refrigeration (lower internal temperature)
When the surrounding temperature is 25°C and the appliance has no foodstuffs in it, it will take
around 3.5 hours to decrease the temperature from 25°C to 17°C (with thermostat on setting 1).
The recommended thermostat setting is the setting 1 of thermostat.
APPLYING THE DRAFT
(see figure 04)
The draft is a device - consisting of two parts, A and B - which connects the door of the Minibar to
the door of the piece of furniture it is fitted into, both when opening and when closing.
To install the draft, proceed as follows:
• screw the part A onto the door of the Minibar;
• open the door of the Minibar by 90°;
• screw the part B, perfectly horizontal, to the inside of the leaf of the piece of furniture, and fit
it into the part A so it can work as a sliding guide;
• fasten the lower part of the refrigerator to the base of the cabinet containing it by means of the
brackets C.
REVERSING THE DOOR OPENING SIDE
(see figure 05)
In the built-in models, the door can be hooked to the door of the cabinet housing it through a
special towing device, which enables simultaneous opening (dragging system). In the case where
the door opens on the opposite side to the cabinet door, it can be reversed as follows:
• undo the screws holding the pin E to the fridge structure;
• remove the cover F;
• unscrew the screws securing pin D to the fridge structure;
• screw pin G into the position previously occupied by pin D;
• screw pin D into the position previously occupied by pin E;
• reposition the cover F on the opposite side of the structure.
15