Teuco X762 Manual Del Usuario página 21

SETTING THE WATER DISINFECTING POWER (ORP)
Set- the- electrolysis- system- to- automatic- mode-
(see- the- section- entitled- "SETTING- THE-
ELECTROLYSIS- SYSTEM- TO- AUTOMATIC-
MODE").
Press-the-"SET"-key-repeatedly-until-the-"Setpoint"-
area-of-the-display-shows-the-required-ORP-value.
The-range-of-possible-values-that-can-be-set-is:-650
mV - 800 mV.-The-range-of-values-that-can-be-set-
is-650-mV---800-mV,-corresponding-to-0.5---1.5-ppm-
of-active-chlorine-depending-upon-other-factors.
pH Electrolysis ORP mV
7.0 690
ORP
7.0
650
« AUTO »
Setpoint Control Mode Setpoint
RECOMMENDED pH / ORP VALUES
INTENSIVE USE
DOMESTIC USE
Remember this rule:
pH   the chlorine is more active (in other words, it acts more rapidly and is used up more
quickly).
pH   the chlorine is less active (in other words, it acts less rapidly and is used up less
quickly).
WATER-TREATMENT-KIT
pH Electrolysis
SET
7.0
ORP
7.2
« AUTO »
Setpoint Control Mode
pH
7
7,2
7,4
pH Electrolysis ORP mV
7.0 ... 7.8 pH 650...800 mV
Setpoint Control Mode Setpoint
AUTO
SET SET
MAN
CAL
STOP
pH CONTROLLER ORP CONTROLLER
ON ALARM
ORP mV pH
SET
690 7.0
7.8
675
Setpoint Setpoint
750-÷-850
700-÷-750
CAL
Electrolysis ORP mV
690
ORP
800
« AUTO »
Control Mode Setpoint
ORP
21
EN