marklin V 60 Instrucciones página 5

Setting Locomotive Parameters with the
Control Unit
1. Requirement: Setup as in diagram on page 20. Only
the locomotive to be changed can be on the track.
2. Press the "Stop" and "Go" at the same time until "99"
blinks in the display.
3. Press the "Stop" button.
4. Enter the locomotive address „80".
5. Hold the control knob in the reverse direction area.
While holding the control knob here, press the „Go"
button.
6. The headlights on the locomotive will blink slowly. If
they don't, repeat Step 2.
7. Enter the register number for the parameter to be
changed (=> List on page 22).
8. Active the change of direction.
9. The headlights will blink rapidly.
10. Enter the new value (=>List on page 22).
11. Active the change of direction.
12. The headlights will blink slowly (exception: factory
reset)
13. Enter the next parameter setting from 6 or end with 14.
14. End the process by pressing the „Stop" button. Then
press the „Go" button.
Changes to the locomotive parameters in the decoder
may only be carried out as described. Märklin is not liable
for changes beyond this that cause malfunctions or da-
mages to the decoder; the cost for any necessary repairs
must be borne by the consumer.
Changing Locomotive Parameters with the
Mobile Station/Central Station
1. Select the locomotive from the locomotive list.
2. Change to the submenu "EDIT LOC".
3. Go to the submenu „VMAX" (maximum speed),
„ACC" (acceleration), „DEC" (brakes),
or
„RESET" (resetting the decoder to factory default
settings).
4. Enter the new value and accept it into the system.
Please note the information in the instructions for the
Mobile Station / Central Station.
5