Trust START-LINE AWST-6000 Manual De Instrucciones página 8

AWST-6000 WIRELESS MOTION SENSOR
EN
7. Set detection angle
The horizontal detection angle of the sensor is maximum 80° and minimum 20°. Remove, reposition
or adjust the size of the plastic screens to change the detection angle. Next, affix the transmitter
using screws or double-sided tape.
8. Affix the transmitter using screws
1. Screw the base of the wireless motion sensor onto a flat surface, e.g. a wall.
2. Press the frame back onto the base and press the sensor into the frame.
3. The sensor needs 30 seconds to analyze its environment, before it becomes operational.
9. Affix the transmitter using double-sided tape
1. Apply double-sided tape to the back of the wireless motion sensor.
2. Stick the wireless motion sensor onto a flat surface, e.g. a closet.
3. The sensor needs 30 seconds to analyze its environment, before it becomes operational.
10. Delete code from Trust Smart Home receiver memory
Read the receiver's manual for the single code deletion procedure. Slide the LEARN switch from [SET]
to [DEL] to send an OFF-signal.
2