Idiomas disponibles
Idiomas disponibles
EN
10.4 INSTALL THE CUTTING LINE
Do not put more than 15 feet of cutting line in at a
time.
1. Remove the remaining cutting line on the spool.
2. Line up the slot on the spool cap with the line exist
hole on the trimmer head.
3. Put the cutting line through the hole. Push the
cutting line until it exits the opposite hole.
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
5. Turn the spool cap clock-wise to wind the cutting
line into the trimmer head. Keep approximately 5 in
of cutting line above out of each side of the trimmer
head.
NOTE
Spool cover
Slot
Line exist
hole
English
10.5 REMOVE THE TRIMMER HEAD
1. Put the metal rod in the specified angle transmission
hole to fix the trimmer head.
2. Turn the trimmer head clockwise to loosen it. Do not
remove the spacer from the shaft.
10.6 ASSEMBLE THE TRIMMER HEAD
1. Put the metal rod in the specified angle transmission
hole to fix the trimmer head.
2. Assemble the trimmer head.
3. Turn the trimmer head counterclockwise to tighten it.
4. Remove the metal rod.
You must install the cut-off blade when you use the
trimmer head.
11
TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
transportation and storage.
12
IMPORTANT
WARNING
