5.
Once the new screen appears, make sure that there is
the correct NAME and PASSWORD of your WI-FI and
proceed. After about a minute the device will be
configured and associated with the application with your
account.
WI-FI configuration, method 2:
1. Press the button on the module for approximately 10 seconds.
The module will start ringing BIP BIP BIP
2. Open the app and press "+" to add the device
3. Select "WI-FI switch" and check that the NAME and PASSWORD
of your WI-FI are correct then press NEXT
4. Check the box "Verify that the LED..." and go FORWARD
After about a minute the device will be configured and associated
with the application with your account.
REMOTE CONTROL PAIRING: Press and hold the button on the
module for about 5 seconds until you hear 2 BEEP BEEPs then
release. Immediately after, press and choice one of the three
buttons on the remote control.
In case of several modules, it is possible to associate them to the
three buttons independently.
RESET WI-FI: Press and hold the button and you will hear BIP BIP,
continue to press until you hear BIP BIP BIP quickly and release.
REMOTE CONTROL RESET: Press the button until you hear 2 BEEP
BEEPs and release. Press again, immediately after, until you hear 4
beeps to reset the memory of the associated remote controls.
ESPAÑOL
Para comenzar, escanee el CÓDIGO QR para descargar la
aplicación HeySmart y registrar una cuenta. Luego, siga el
esquema de cableado y proceda con la configuración de WI-FI.
Atención: La instalación debe ser realizada por un electricista
calificado de acuerdo con las regulaciones locales. El módulo
funciona con una red Wi-Fi de 2,4 GHz. La banda de 5GHz no es
compatible.
Installation: el módulo inteligente puede funcionar con o sin el
botón ARRIBA/ABAJO. Siga el esquema de cableado anterior A o B.
El control remoto funcionará en ambos casos.
Configuracion WI-FI metodo 1:
1.
Conéctese a su red WI-FI de 2,4 GHz y active Bluetooth y
GPS/Ubicación en su teléfono inteligente.
2.
Abra la aplicación y presione "+" para agregar un
dispositivo.
3.
El dispositivo será detectado gracias a bluetooth luego
presione "AÑADIR"
4.
Presiona "+" nuevamente y espera
