Idiomas disponibles
Idiomas disponibles
Connector
The connector is an RF receiver with a Wi-Fi access point,
which allows you to connect RF sensors to the internet.
1.
Connector Installation
Note: This device works on a 2.4GHz frequency
(it does not support 5g), during the connection
process the mobile phone used for the link must
be connected to the 2.4GHz network. For more
information, contact your internet service provider.
- Install the App "Energeeks 3.0" on your mobile
phone, register you in the App and enter to install
the connector.
- Plug the connector into the electrical current,
wait a few seconds to start, press the "options"
button for three seconds, until you hear a beep, the
blue LED that blinked slowly now blinks quickly.
- In the App press the + button to add a new device
manually and select "connector".
- Confirm that the connector is in connection
mode, enter your Wi-Fi password (2.4g) and press
confirm.
If the connection fails, reboot the router, check that
the mobile phone is connected to a 2.4g network and
try again.
33
