Idiomas disponibles
Idiomas disponibles
Clearing the programming
4
Press the „Up" and „Down" but-
tons at exactly the same time to cancel
the programmed extension length. You
will hear a double tone.
Using the adjusting screws
If setting the extension length by remote control
is not accurate enough for you, you can adjust
the extension length with the adjusting screws.
These are located on the right side of the screen,
FAQ
Question / Problem
The weight bar does not
fit completely into the
housing
The canvas is emitting an
odour
The canvas is wavy
on the shaft around which the screen is wound.
You can reach the screws through the opening
where the screen extends from the housing. The
upper screw controls the retraction, and the lo-
wer screw controls extension of the screen. Sin-
ce the adjustment of these screws can easily cau-
se damage to the screen, we do not recommend
making adjustments to these screws. Damage to
the screen due to adjustment of these screws is
not covered by the manufacturer's guarantee.
Solution
• MIMOTO screens are shipped with a sleek and stylish SlimFit
housing. The weighting bar therefore does not fit into the
housing.
• Please take out the screen completely a few days before first
use, to allow any odours from the production process to
evaporate from the screen material. Low room temperatures
and lack of ventilation will lengthen this process.
• Unfortunately, a slight rippling of the screen due to its being
rolled up cannot be entirely avoided. The only screens
which are entirely ripple free are completely tensioned fra-
me-screens, which unfortunately you cannot roll up after use
to save space. Therefore, rolled screens are an acceptable
compromise for most users.
• However, you can optimize the surface by removing one
of the PVC side panels at the bottom weighting bar (1),
tightening the tension cable (2) and clamping it down again
with the PVC cover.
1
2
3
25
