Idiomas disponibles
Idiomas disponibles
Contents
•
User Safety
•
Battery Safety
•
Setup (Load Batteries)
•
Operation
•
Warranty
•
Error Codes
•
Specifications
EU/GEM
Retain all sections of this manual for
future reference.
User Safety
WARNING: Carefully read the Safety
Instructions and Product Manual
before using this product. The person
responsible for the product must ensure
that all users understand and adhere to
these instructions.
WARNING: The following label
information is placed on your laser tool
to inform you of the laser class for your
convenience and safety.
The STHT77100 tools emit a visible laser beam,
as shown in Figure A
emitted is Laser Class 2 per IEC 60825-1.
WARNING: While the laser tool is in
operation, be careful not to expose your
eyes to the emitting laser beam (red
light source). Exposure to a laser beam
for an extended time period may be
hazardous to your eyes. Do not look
into the beam with optical aids.
WARNING: To reduce the risk of
injury, user must read the Product User
1
. The laser beam
manual, Laser Safety manual, and
Battery Safety information.
CAUTION: Use of controls or
adjustments or performance of
procedures other than those specified
herein may result in hazardous
radiation exposure.
Battery Safety
WARNING: Batteries can explode or
leak and cause serious injury or fire. To
reduce the risk:
•
ALWAYS follow all instructions and
warnings on the battery label and package.
•
DO NOT short any battery terminals.
•
DO NOT charge alkaline batteries.
•
DO NOT mix old and new batteries. Replace
all of them at the same time with new
batteries of the same brand and type.
•
DO NOT mix battery chemistries.
•
DO NOT dispose of batteries in fire.
•
ALWAYS keep batteries out of reach
of children.
•
ALWAYS remove batteries if the device will
not be used for several months.
NOTE: Ensure that the recommended
•
batteries are used.
NOTE: Ensure the batteries are inserted in the
correct manner, with the correct polarity.
Setup (Load Batteries)
1. Locate the battery compartment latch on
the back of the tool (Figure D
2. Using your finger, pull the latch up to
unlock and remove the battery door
1
(Figure E
and
3. Insert two AAA batteries, making sure to
position the - and + ends of each battery
as noted inside the battery compartment
3
(Figure E
).
4. Slide the pins at the bottom of the battery
door into the notches in the battery
compartment (Figure E
2
).
2
).
4
).
E
5
