Know Your Heater
Control panel
Ornament ring
LED screen
Wind outlet
Front frame
Fix bracket
Steel Rod
Front basis
Assembly your heater
Step 1
Screw
Basis
Step4
Fix bracket
fixing hole
Groove
www.costway.com
Top cover
Back
frame
Main Switch
Wind inlet
Rear basis
Step3
Step2
Screw shaft
rod
Pillar
Limit hole
Step5
Step6
screw
Hole location
04
Using the heater
Fan
Lower power
Full power
Stand by
ON/OFF
Power
• Before inserting the plug into an electrical outlet, make sure that the electrical supply in your area matches that
on the rating label on the unit.
• When plugged in, turn on the Main power switch at the back of the unit.
• When in Standby mode, only the switch
display shows the room temperature. Press
a)Low Power: (Press "
" to switch it)
b)High Power: (Press "
"to switch it)
c)TIMER: Press "
" button repeatedly to set a period after which the heater will turn itself off
(From 0 hour to 8 hours).
d)+ , - : adjust room temperature only by remote control.
• Temperature setting from 10 to 49 degrees. "+" to increase the desired temperature and "-" to decrease the
desired temperature. (On Remote control only)
• The heater works on full power when the room temperature is 4℃ lower than the setting temperature.
• The heater works on half power when the room temperature is between 0℃ and 2℃ lower than the setting
temperature.
• The heater switches off when the room temperature is higher than the setting temperature. The fan works 30
seconds to make the inside cool to protect components, then the fan stops and the unit enters into standby.
• The heater switches on again when the room temperature falls 2℃ below the setting temperature.
e)OSC : Press "
"to activate oscillation. Press it again to cancel.
f)Press
to turn off the heater, the unit will keep working 30 seconds of cool air after turn off it .
this design can protect item use longer.
Warning: The heater will remain hot for some time after it is turned off; handle with care.
www.costway.com
Temperature light
Swing indicator
Timer indicator
Timer
Remote controller
Swing
on the control panel will respond to your touch, and the LED
to access the rest of the control panel or remote control
05