Idiomas disponibles
Idiomas disponibles
3.3. Working with the device
CAUTION! Before working with the device, check the correctness of
assembly of the device components and the stability of the surface
to which the structure is installed!
INSTALLATION AND OPERATION OF THE APPLIANCE
a) Place the locking pins in the slots in the rail (1).
b) Join the rails by adjusting the splicing and pressing it into the center point (2).
c)
To ensure adequate stabilization, place the mounting plate on the rail joint.
Attach the structure with the dedicated fasteners (3).
d) Attach the sensor of the device to the end of the rail (4).
NOTE: When installing the first sensor, take into account the appropriate
distance over which the device should move.
e) Attach the structure prepared in such a way in the place of operation chosen
by the user, in accordance with the spacing of the mounting holes and keeping
the minimum height of the installation (5).
ATTENTION: The place of installation should provide proper stabilization!
When installing, take the weight of the unit and the unit under load into
account! It is forbidden to install the device on a structure of inadequate
quality!
f)
Slide the drive of the device onto the rail so that the guide rollers are located
inside the edge of the rail (6).
g) Fasten the limit switch in the given location, respecting the previously
determined distance (6).
h) Set the start delay time using the knob (2) on the control unit cover (1).
NOTE: Setting the system start delay is responsible for stopping the mechanism
for a certain time at the sensor after covering the set distance. Then, the
movement in the opposite direction is resumed.
i)
Attach the external lighting device to the mounting hook of the mechanism
(5).
ATTENTION: Pay special attention to the electric wires of the installed
mechanism and the external device! Keep a safe distance!
j)
Connect
After connecting the device to the power supply, the system will automatically
start working.
the
device
to
the
power
supply.
