Idiomas disponibles
Idiomas disponibles
FILTER CLEANING AND REPLACEMENT
HEPA Filter
1. Suction performance can be maintained with the Filter Cleaning System. Eventually
filters will need to be washed or become worn and need to be replaced. To clean or
replace the filter:
a. Turn switch off (0) and unplug power cord from the electrical outlet.
b. Remove hose from suction inlet. (See Figure 3)
c. Remove head from the tank by pulling gently on the clamps on the vacuum head,
turn the head upside down.
d. See Figure 9. Remove the 4 screws fixing the filter frame to the head.
e. See Figure 10. Remove the filter frame (A) and the filter (B).
f.
Insert a new filter into the filter frame and place it on the head. Use only filters
from model FSM1 to insure that you have a genuine replacement filter. To
purchase a FSM1 Filter Kit. See instruction for ordering filter kit below.
g. Insert the 4 screws. Do not over tighten the screws. Use an appropriate screw
driver.
h. Check to insure that the filter is properly in place and there is a proper seal
between the head and filter frame.
i.
Attach head to the tank, ensuring they are securely clamped together.
Use only replacement filters from a FSM1 Filter Kit. This kit contains a HEPA filter and a
post filter. To order a FSM1 Filter Kit, contact Customer Service at 866-814-4103 or
Never machine wash or machine dry filters.
Post Filter
2. The post filter ensures that very fine dust does not escape when using the filter cleaning
button.
3. See Figure 11. To clean or replace the post filter move the latch (A) down by pushing the
button. Take out the filter (B).
Figure 9
Figure 11
Figure 10
10
