Idiomas disponibles
Idiomas disponibles
Connect tool to air hose of recommended size. NOTE: The use of a quick connect
l
set makes connecting easier.
IMPORTANT: The use of air filters and air line lubricators is
recommended.
To use:
Turn air compressor on and allow air tank to fill.
l
Set the air compressor's regulator to 90 PSI. This tool operates at a maximum
l
90 PSI pressure.
Depress trigger to operate tool.
l
Release trigger to stop tool.
l
Adjust variable speed by turning regulator knob
l
counterclockwise for more air and clockwise for less
air.
Always disconnect air supply when changing
l
sandpaper pads.
When job is complete, turn the air compressor off
l
and store as described in the air compressor operator
manual.
Tips
Begin sanding with an abrasive grit sandpaper coarse enough to remove the high
l
spots. Progress to a finer grit sandpaper until the desired finish is obtained.
Never change from coarse grit sandpaper to a very fine grit sandpaper, always
l
progress to the finer grit.
Lubrication
Air tools require lubrication throughout the life of the tool. The air motor and bearing uses
compressed air to power the tool. Because moisture in compressed air will rust the air
motor, you must lubricate the motor daily. An inline oiler is recommended.
To lubricate the air motor manually:
Disconnect the tool from the air supply holding it so the air inlet faces up.
l
Depress the trigger and place one to two drops of air tool oil in the air inlet
l
Depressing the trigger helps circulate oil in the motor. NOTE: Use SAE #10 weight oil
if air tool oil is not available.
Connect the tool to an air source, cover the exhaust end with a towel and run for a
l
few seconds.
away from people or objects.
D22719
MAINTENANCE
Any excess oil in the motor is immediately expelled
from the exhaust port. Always direct exhaust port
Failure to lubricate the tool at the air inlet will void
your warranty.
6- ENG
counter-
clockwise
clockwise
