Idiomas disponibles
Idiomas disponibles
You can now remove the standard stem. Once the standard stem has been re-
moved, the steps to mount the long stem are the same.
First, run the motor cables through the bottom of the stem. The top has a screw
thread in addition to the two pin holes. The lower one, only the pin holes. In other
words, the upper part has 3 holes and the lower part only two.
When you put it in position, remember to insert the trim, the rosette and the
coupler before putting the upper pin.
1. Assemble the stem in this way, remember to put the type R hook to the
lower pin so that it does not come out and tighten the screws so that the
stem is attached correctly to the motor. Don't forget to run the cables all
the way through the stem.
2. Place the remaining pin at the top of the stem.
37
EN
