Idiomas disponibles
Idiomas disponibles
Allow the battery to charge for 3-5 hours. This time
is enough for a full charge. Unplug the charger after
this time.
When the battery is charged for the fi rst time or after
long-term storage, it will receive approximately 60%
of its capacity. However, after several charge and
discharge cycles, the battery reaches 100% of its
capacity.
After charging is fi nished, pull out the charging
adapter from the plug, then pull out the charging plug
from the charging socket. The cordless screwdriver is
ready for use.Attention:
Never use a screwdriver when charging the battery.
Check the battery charging status of the screwdriver.
Battery charge status.
Press the button on the cordless screwdriver. Three
LEDs will show you the battery charge status.
If all are lit - red, yellow and green: the battery is fully
charged.
When red and yellow are on: the battery is half char-
ged. If red: the battery is almost empty.
Fitting and replacing bits
When using any of the supplied bits, insert the bit into
the bit holder and push the holder into the chuck as
far as it will go. To remove a bit, simply pull it out of
the bit holder.
NOTE: Always use a bit holder when clamping short
bits!
On and off
You can turn on the cordless screwdriver by pressing
and holding the switch (4).
Switch off the cordless screwdriver by releasing the
switch (4).
Change direction of rotation
You can change the direction of rotation with the slide
switch (6).
Lighting (F)
LED lighting allows you to work even in poor lighting
conditions. The light is switched on and off with switch
No. 4.
Change Position
To achieve a more comfortable working position when
working, press the button (9) and turn the handle of
the screwdriver to the appropriate position that suits
you better. Attention! Allow the handle to engage as
far as it will go.
General instructions
Make sure the bit used matches the screw head and
its size.
If you use bits that are too small or too big, you will
damage the screw head. This is especially important
for screws that need to be tightened or loosened
regularly.
Note the diff erences between the various attachments
eg PZ (Pozi) and PH (Phillips). If you tighten the PZ
screw with the PH attachment, you will damage the
notch in the screw head.
Improper attachments can slip off the screw and
cause injury.
CLEANING AND MAINTENANCE
Clean the tool with a damp cloth only - do not use any
solvents! After cleaning, dry the tool properly. To pre-
serve battery capacity, we recommend fully dischar-
ging the battery and recharging it every two months.
Storage if the tool is not used for a long time
Mismatch of tools
in a place where the temperature is high.
If possible, store tools in a place with constant tempe-
35
