Adjust The Cutting Angle - PRETUL CALA-P3 Manual

Start Up
Start and Operation Control
• Intermittent Operation:
Connect the plug into the power outlet.
B
Press the switch (A) to start the tool.
To stop the tool, simply release the switch.
• Continuous Operation:
Connect the plug into the power outlet.
Press the switch (A) and block it pressing the continuous use button (B).
To stop the tool, press and release the switch.
A

Adjust the Cutting Angle

• Disconnect the unit from the power source.
• Loosen 2 screws (C) in the shoe base using the
Hex key included.
• When the screws are loosened adjust the base
into the desired angle according to the scale
marked in the shoe.
C
• Tighten back the screws.
• Set the Hex key in its support set in the power
cord immediately after using it.
Vacuuming Particles
• Connect a vacuum cleaner to the tool using the vacuum
cleaner connection to vacuum clean dust, saw dust or any
particle from the work piece.
Dust
Collector
Lubrication
• Apply regularly one drop of lubricant to the guide roller to
gain an adequate sliding of the saw blade while cutting.
7
ENGLISH