Safety Information
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical products, basic precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY
a)
INSTRUCTIONS.
b) This product is for indoor use only. The electrical rating 12 Vcc 24 W.
c) Do not use seasonal products outdoors unless marked suitable for
indoor and outdoor use. When products are used in outdoor applications,
connect the product to a Ground Fault Circuit Interrupting (GFCI) outlet. If
one is not provided, contact a qualified electrician for proper installation.
d) This seasonal use product is not intended for permanent installation or
use.
e) Do not mount or place near gas or electric heaters, fireplace, candles or
other similar sources of heat.
f) Do not secure the wiring of the product with staples or nails, or place on
sharp hooks or nails.
g) Do not let lamps rest on the supply cord or on any wire.
h) Unplug the product when leaving the house, when retiring for the night,
or if left unattended.
i) This is an electric product – not a toy! To avoid risk of fire, burns personal
injury and electric shock it should not be played with or placed where small
children can reach it.
j) Do not use this product for other than its intended use.
k) Do not hang ornaments or other objects from cord, wire, or light string.
l) Do not close doors or windows on the product or extension cords as this
may damage the wire insulation.
m) Do not cover the product with cloth, paper or any material not part of the
product when in use.
n) Do not move the tree by pulling the tree tips or tree branches.
o) Do not use an extension cord.
p) Reference the National Electrical Code, ANSI/NFPA 70, specifically for
the installation of wiring and clearances from power and lighting
conductors.
q) Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and standards,
including fire-rated construction.
r) Do not install or use within 3 m of a pool.
s) Do not use in a bathroom.
WARNING:
t)
Risk of Electric Shock. When used outdoors,
install only to a covered Class A GFCI protected receptacle that is
weatherproof with the power unit connected to the receptacle. If one is
not provided, contact a qualified electrician for proper installation. Ensure
that the power unit and cord do not interfere with completely closing that
receptacle cover.
WARNING:
u)
Risk of Fire. Installation involves special
wiring methods to run wiring through a building structure. Consult a
qualified electrician.
WARNING:
v)
Not for use with receptacles that are
weatherproof only when the receptacle is covered (attachment plug cap
not inserted and receptacle cover closed).
w) Read and follow all instructions that are on the product or provided with
the product.
SAVE THESE INSTRUCTIONS.
x)
2.74 m LED Jackson Noble Fir Color Changing
Micro Dot Tree
SKU# 164086
Pre-Assembly
Package Contents
A. Top Section
B. Upper Middle
Qty: 1
Section
Qty: 1
D. Tree Bottom
E. Stand with an
Qty: 1
eye bolt
Qty: 1
G. Remote Control
H. Rivet
Qty: 1
Qty: 2
Assembly
Assembling the tree stand
Step 1. Choose a location near a wall outlet.
Step 2. Open the stand to a 90 degree angle until the hole lines up with the
hole on the tube.
Step 3. Screw an eye bolt into the hole.
CAUTION! –
ALWAYS UNPLUG YOUR TREE
FROM ITS POWER SOURCE BEFORE ASSEMBLING OR
DISASSEMBLING.
C. Lower Middle
Section
Qty: 1
F. Power Cord with
a foot pedal
switch
Qty: 1
I. Threaded iron rivet
Qty: 2
J. Retainer washer
Qty: 4