Idiomas disponibles
Idiomas disponibles
Mechanical
•
To ensure safe operation, the equipment must be firmly fixed.
•
The installation must prevent contact with the fan's impeller through the use of grilles, accessories, or by installing
a connecting tube of a suitable length.
•
Do not connect the elbows close to the equipment's connecting flanges or clamps.
•
Sufficient space must be provided for opening the hinged hatch cover. Not included in models 100, 125 and
150/L, which must be disassembled by completely removing the cover (Fig. 1).
•
The equipment may be floor, ceiling or wall mounted; the box has built-in fixing points for this purpose (Fig. 2).
•
The equipment must be installed in such a way that the whole of its surface area is adhered to the surface on
which it is installed.
•
If the equipment is mounted on a wall, it may transmit noise or vibrations, even though the equipment's noise level
is acceptable.
•
The installation must be such that the weight of the duct system is not supported by the equipment.
•
When connecting the ducts, ensure that the airflow direction is correct in accordance with the arrows indicating
flow direction through the equipment (Fig. 1.2).
•
The use of air filters is recommended to reduce the amount of dirt that accumulates in the impeller, since this may
affect its balance and cause vibrations.
•
Once the mechanical assembly is complete, it is important to check that the impeller turns freely, with no friction or
tension.
•
Tighten the cover screws correctly, to prevent it from opening.
•
If there is a possibility of water condensing in the equipment, external preventive measures must be taken.
Electrical
•
Check if the equipment is connected to the power source in accordance with the instructions on the connection
diagram in this document (Fig. 3), and on the cover of the connection box.
•
Select a power cable with a suitable cross-section for the current used by the equipment.
•
IMPORTANT: When the equipment is controlled by reducing the voltage, the motor current may be higher than
the rated value.
•
Check if the electrical characteristics stated on the plate correspond to the power supply.
•
An external protective component must be connected (a relay, magneto-thermal protection system or fuse), in
accordance with current regulations.
•
The equipment's earth connection must be connected.
•
If the motor speed control is used, it must be guaranteed that the motor will operate correctly.
•
It is necessary to ensure a minimum rotation speed that will allow the extraction non-return valves to be activated
(if they have been installed).
Start-up
•
After starting up the motor, it is important to check that the motor is turning correctly, without vibrations or unusual
noises.
•
A check must be made to ensure that the motor's actual power consumption does not exceed the level stated on
the equipment's label and that it does not heat up excessively.
•
The machine must not be switched on and off intermittently, as this could damage the winding of the motor or the
insulation, due to overheating.
7. Maintenance
Maintenance must be performed by qualified technicians.
•
The fan bearings require no maintenance.
•
If the fan is not equipped with an air filter, the only maintenance required is to clean the impeller; this must be
done at least once every six months.
•
Care must be taken when cleaning the impeller, in order not to affect its balance.
•
It is not advisable to use chemical cleaners or aggressive substances, as they could damage the equipment.
•
If a part must be replaced, consult the distributor.
8. Disposal
Careless or negligent disposal of the equipment may cause contamination. The disposal process must be carried out in
compliance with the standards and regulations applicable in the country.
9. Warranty
Incorrect use of the equipment and failure to observe the instructions in this manual may result in the cancellation of the
warranty.
