YATO YT-85930 Manual Original página 13

GB
with a strainer, which must be cleaned under running water. It is forbidden to use the washer without the strainer installed in the
water inlet. Deformation or reduction of the effi ciency of the outlet jet can be caused by a dirty nozzle outlet. Clean the nozzle inlet
with a needle. Be careful when cleaning so as not to damage the nozzle. If the cleaning has no eff ect, hand over the washer to an
authorised service centre. Do not disassemble any of the parts of the washer by yourself.
Remove water from the inside of the washer before storage. This will prevent contamination of the washer by organic material
which may be present in the water, and damage to the washer if exposed to temperatures below 0 C. After using the washer and
O
disconnecting the water supply hose, run the washer for 5 seconds. This will remove as much water as possible from the inside of
the washer pump. Do not run the washer for more than 5 seconds, as this will damage the washer pump.
Store the washer in dry, dark places and ensure good ventilation. Do not store the washer at temperatures below 0 C. The place
O
of storage should protect the device from access by unauthorised persons, especially children.
Store and transport the washer with disassembled battery.
It is advisable to disconnect the lance before transport over longer distances and then cover the water inlet and outlet.
O R I G I N A L I N S T R U C T I O N S
13