Idiomas disponibles
Idiomas disponibles
GB
Recommendations for connecting the device to the water supply
The device may only be used with clean, fresh water. Do not use mechanically or chemically
contaminated water.
Do not use liquids other than clean, fresh water, in particular alcohol, solvents, acids as well
as aqueous solutions of substances. Do not use the device for spraying plants with substanc-
es other than water.
Do not exceed the maximum water inlet pressure. When performing water suction with the
device, do not exceed the maximum suction height.
Do not allow water fl ow through the device to stop. Otherwise, this could lead to its overheat-
ing and damage.
If there are any leaks of the hose supplying water to the device, stop using it and replace the
hose with a new one, free of defects.
When using detergents, use only those that are intended for use in pressure washers. Do not
use kitchen detergents. Do not use corrosive or abrasive detergents.
Place the detergent only in the container intended for this purpose. Do not dilute the deter-
gent in water intended for supplying the device.
Instructions for use
Do not point the water jet at equipment containing electrical components, such as the inside
of the ovens.
Never point the water jet towards yourself, other people or animals.
The product is intended for indoor use only. Do not expose the product to any precipitation or
moisture. If water and moisture enter the product, the risk of an electric shock is signifi cantly
increased. Do not immerse the product in water or any other liquid.
The device may only be used at temperatures above 0
C.
O
After each use, disconnect the battery from the device. Always disconnect the device from the
power supply, if it is left unattended, and before putting it away, disassembling, or cleaning.
Disconnect the battery from the device, before installing, removing, or adjusting any of the
product accessories.
Make sure that the selected accessory has been installed correctly, before starting the product.
Do not overload the product. The temperature of the housing must not exceed 60
C. Over-
O
loading the product will accelerate its wear and tear, lead to its damaging, and increase the
risk of an electrocution.
The product must be kept under supervision at all times during operation.
Improper use
Do not use the pressure washer for the following purposes: spraying hot water (above 50
C);
O
cleaning electrical equipment; as a pump; spraying fl ammable liquids; spraying liquids other
than water. Do not use the device to spray sea water.
WARNING! Danger of explosion - Do not spray fl ammable liquids.
Do not spray toxic, corrosive or hazardous liquids.
O R I G I N A L
I N S T R U C T I O N S
11
