Locking The Brake; Installing Additional Lights; Adjusting The Handlebar; Securing The Cover - Burley Encore X Manual De Instrucciones Y Seguridad Del Propietario

Locking the Brake

1
to lock the brake, slide the lever
to the right. to release the brake,
slide the lever to the left.

Installing Additional Lights

1
Fabric loops are located on the back of
the trailer fabric and should be used to
attach additional lights and/or reflectors.
12
ASSEMBLY & uSE

Adjusting the Handlebar

1
Bike Trailer Mode: Always rotate the
handlebar forward when using as a bike
trailer. the handlebar should be horizontal
and parallel to the ground, such that
the mark on the handlebar is aligned
with the bolt that attaches the cover.

Securing the Cover

Slip the cover d-rings over the hooked
corners of the tow bar receivers.
ENG
2
Stroller Mode: rotate the handlebar
to serve as a handlebar while using
as a stroller. open lever to rotate
and close lever to lock in place.
1
DEU FRA ESP
WARNING
ALWAYS uSE tHE
JoGGInG tEtHEr WHEn
uSEd AS A StroLLEr
note
the handlebar lever tension is
optimally adjusted from the factory. If
the handlebar slips when lifting up or
pushing down – or if it makes excessive
noise when rotating – the lever tension
can be fine-tuned. release the lever,
squeeze the handlebar tube together
and turn the barrel nut in 180 degree
increments. Adjust the barrel nut to
desired tension.

Installing the Flag

1
depress the yellow button and slide the flag
pole into hole on flag holder. to release, depress
the yellow button and lift flag pole out.
.
BURLEY.COM