Idiomas disponibles
Idiomas disponibles
Lubricating the Motor Gear Reducer
The Motor Gear Reducer Assembly is a sealed unit.
Therefore, no lubrication is required.
Replacing the Lamp
Figure 2 Cross section of light
Parabolic
Mirror
7.25 in
(18.42 cm)
To replace the lamp:
1.
Disconnect power from the electrical circuit.
2.
Remove the retaining screw located at the bottom
of the dome.
3.
Grasp the top of the dome and push down while
turning the dome counterclockwise approximately
3/4" (19 mm). A strap wrench may be used to
remove the dome if necessary.
4.
Gently lift the dome away. Ensure that the gasket
between the dome and base is not lost.
5.
Replace the lamp with Part Number K14702196A.
6.
Before replacing dome, ensure that the gasket is
properly seated.
7.
Place the dome over the base, aligning the recesses
inside the dome lip with the four pins on the base.
8.
Push down on the dome and turn clockwise until it
locks in place (approximately 3/4" [19 mm]).
9.
Insert and tighten the retaining screw into the
bottom of the dome.
10.
Apply power and test the light for proper operation.
NOTE: The LED lamp is a suitable replacement for older
incandescent models.
Cleaning the Fixture
The fixture should be cleaned periodically to maintain
maximum light output. Use only mild, non-abrasive
cleaning agents. The dome should be regularly inspected
2
5.5 in
(14.0 cm)
Dome
LED
Retaining
Screw
for scratches and chips, and if damaged, it should be
replaced.
Maintenance and Service
Technical Assistance: Contact our Technical Support
Team at +1 708-587-3587 or [email protected].
Repair Service: A return authorization is required. Contact
your Authorized Distributor or Federal Signal Customer
Support. Defective products under warranty will be
repaired or replaced at Federal Signal's discretion.
Product Returns: Returns require authorization from
Federal Signal. Contact your Authorized Distributor for
more information on our return policy or to request a
return.
Replacement Parts
Contact the factory for spare parts availability and part
numbers. Typical spare parts are listed below. Due to
certification, certain component parts are not available
for field replacement. Units with this type of damage must
be either replaced entirely or returned to Federal Signal
for service.
Table 1 Replacement Part
Description
Dome Assembly, Amber
Dome Assembly, Blue
Dome Assembly, Clear
Dome Assembly, Green
Dome Assembly, Red
LED Lamp
Table 2 Optional accessories
Description
Light Mounting Kit, Type 4X/IP66
Mounting Bracket, Wall
Mounting Bracket, Corner
Federal Signal signaling.fedsig.com
Part Number
K8444D219C-03
K8444D219C-01
K8444D219C-04
K8444D219C-02
K8444D219C
K14702196A
Part Number
LSWB
LWMB2
LCMB2
