Idiomas disponibles
Idiomas disponibles
performance, carry out the following procedures periodically.
-
Empty the robot's dust tank.
-
Press the dust tank's release button. Fig. 39
-
Open the dust tank and empty it. Fig. 40
Robot filter cleaning.
-
Remove the filter.
-
Carefully shake off all dust from the filter. Fig. 41
Free-fall sensors cleaning
Use a clean, dry and soft cloth to wipe off any dust from the free-fall sensor located on the
right side of the robot's bottom part.
Warning
Do not spray cleaning products directly on the sensor. Fig. 42
Main brush cleaning
-
Slightly press the main brush frame's tabs in order to open the main brush storage
compartment and to remove it. Fig. 43
-
Remove any hair, fluffs or dust collected in the brush and around the axes. Fig. 44
-
Clear and clean the robot's suction channel. Fig. 45
-
Reinstall the main brush and its frame. Fig. 46
High-efficiency filter
-
The high-efficiency filter is designed with fibres that help trapping dust particles, dust
mites, pollen... It is very important to clean periodically the filter, to avoid these particles
from building up in the filter, causing efficiency loss. It is convenient to carry out this
maintenance once a week.
-
It is recommended to replace the filter with a new one without exceeding 160 cleaning
hours.
Recommendation
Dirt can be removed with a small brush or by shaking it carefully against a hard surface for
dust to fall off. The high-efficiency filter cannot be washed.
Mesh primary filter and sponge filter
The filtering system is featured with a mesh primary filter and a sponge filter. It is suggested
to replace them either after a maximum of 160 hours of use or when they are worn out due to
operation.
ENGLISH
63
