Wipe the front and back of the product with water-soaked soft cloth.
If dust of other exterior substance has accumulated on the condenser, wipe off with
water-soaked soft cloth.
After cleaning the product, completely dry it. Fill the water to the tanks until waters
comes out of the hot water faucet, then connect the electric power plug. If the surface
of the electric heater in the hot water tank is deposited by water deposition, heating
capacity will decrease. Fill hot water tank with aqueous solution of 2% aitric acid and
keep for about two hours then cleaning. If the problems can not be solved, contact
your dealer or the Service Center of our company.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
PROBLEM
Water dispenser does not operate.
Water cooler is not cold enough.
Water dispenser hot water is not hot
enough.
Compressor turns on and off frequently.
Vibrations.
The water dispenser seems to make too
much noise.
Bottle feels warm.
Water bottle is hot.
TROUBLESHOOTING GUIDE
POSSIBLE CAUSE
Not plugged in.
The circuit breaker tripped or a blown fuse.
Check to be sure the cold switch on the back is
ON.
The water dispenser does not have the correct
clearances.
Check to be sure the hot switch on the back is ON.
The room temperature is hotter than normal.
The temperature control is not set correctly.
The water dispenser does not have the correct
clearances.
Check to assure that the water dispenser is level.
The rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant in your water
dispenser.
Contraction and expansion of the inside walls may
cause popping and crackling noises.
The water dispenser is not level.
The water system is overfilled. Dispense Cold
water until air is released into the bottle.
Water is boiling in the hot tank and bubbling up
into the bottle. Press the hot dispenser button
until water flows to remove air from the hot tank.