Idiomas disponibles
Idiomas disponibles
against it 10.
USE
Shaft ②
• Fold the front and back part together (2a).
• Push the folding lock D to the right position and keep the tip adjacent to the handle .(2b)
• Press the folding lock D towards the handle until the end. (2c) Unfold the handle by pushing the
folding lock to the inside.
Replace sanding pad ③
• Insert the hex wrench R (size 5) into the hexagonal screw bolt on the sanding block.
• Hold the sanding pad firmly, and then turn the wrench counter clockwise to dismount the pad.
• Install new sanding pad by tightening the bolt.
WARNNING: Only install the specified sanding pad on the machine. In order to ensure optimal
performance, the machine should be run at slightly lower speed for several minutes to make the
grinding pad fit the sealing surface perfectly. During this process, the white foam particles will come
out from the sanding head. However, this won't damage the machine.
Attaching and changing sanding disc ③
• Place the sanding disc in the center of the sanding pad and press on. The holes in the sanding
disc must be in alignment with the extraction holes in the sanding pad.
• For round sanding pad only: conduct a test run to check that the sanding disc is clamped in the
centre.
Extension shaft(optional) ④
• use the extension shaft (O) according to the intended operation for higher work surface
• loosen the sleeve on the dust extraction outlet (N) of the upper shaft (F).do not remove the sleeve
from the outlet.
• align the rear handle (O1) with the main handle (E) and insert the sleeve (O3) on the extension
shaft (O) into the outlet (N) with a twist motion all the way to the stop.
• adjust the length of the extension shaft (O) if necessary.pay attention to the marking "max 1.65m"
on the extension shaft.tighten the sleeve (N) after assembling/adjusting the extension shaft.
Dust suction ⑤
• Loosen locking knob for length adjustment N by turning it in the direction of the unlocking symbol
on the tool handle.
• Insert Vacuum hose P into the end of the tool handle as illustrated.
• Tighten Locking knob for length adjustment N by turning it in the direction of the locking symbol
on the tool handle.
• Connect the Vacuum hose with the Ø 47 mm adapter P4 directly to an industrial vacuum cleaner
(remove vacuum cleaner hose first).
• One may also connect vacuum hose with one of the 3 adapters to an industrial vacuum cleaner
without removing the vacuum cleaner hose.
Tool standard/airflow control ⑧
• Tool handle P1 prevents the hose from damage when putting the tool aside during
work breaks.
• Control the airflow by sliding suction power adjustment ring P3 over the opening in
10
