Idiomas disponibles
Idiomas disponibles
Charger Fault Codes
Code
F-0-0-1, F-0-0-2
F-0-0-3, F-0-0-4
F-0-0-6
Visit www.youtube.com/deltaqtechnologies for instructional videos.
Charger Error Codes
Code
Description
E-0-0-1
Battery high voltage
E-0-4-7
BMS or battery fault
E-0-0-4
detected
Battery amp hour limit
E-0-0-7
exceeded
E-0-1-2
Reverse polarity error
E-0-3-7
Re-programming failed
High AC voltage error
E-0-2-3
(>270VAC)
E-0-2-4
Charger failed to initialize
Low AC voltage/ oscillation
E-0-2-5
error
Delta-Q IC650 User Manual – Multiple Languages
Solution
Internal charger fault. Remove AC and battery for minimum 30 seconds and retry
charger. If it fails again, please contact the manufacturer of your vehicle or machine.
Solution
Check the battery voltage and cable connections. Check battery size
and condition. This error will clear once the condition has been
corrected.
Refer to unit's operator manual.
Possible causes include poor battery health, very deeply discharged
battery, poorly connected battery, and / or high parasitic loads on
battery while charging. Possible solutions: Replace battery pack.
Check DC connections. Disconnect parasitic loads. This error will
clear once the charger is reset by cycling DC.
Battery is connected to the charger incorrectly. Check the battery
connections. This error will clear once the condition has been
corrected.
Software upgrade failure or script operation failure. Check new
software is correct.
Connect charger to an AC source that provides stable AC between 85-
270 VAC/45-65 Hz. This error will clear once the condition has been
corrected.
The charger has failed to turn on properly. Disconnect AC input and
battery for 30 seconds before retrying.
AC source is unstable. Could be caused by undersized generator
and/or severely undersized input cables. Connect charger to an AC
source that provides stable AC between 85-270 VAC/45-65 Hz. This
error will clear once the condition has been corrected.
Copyright © 2022 Delta-Q Technologies Corp
Page 6 of 35
Danish / Dansk
