HTC HRT-70 Manual Del Operador página 3

Assembly Instructions
1. Identify all components and hardware.
2. Remove inner leg wedge , and mount leg brace  as shown in Figure
1. The hinge pin positioning is an important assembly element. The pin
must be oriented as in Figure 1 for the unit to fold correctly. The hinge
mounts to the inside face on the open side of the wedge. Use (2) 10‑24 x
1/2" button head bolts and (2) 10‑24 keps nuts.
3. Insert inner leg wedge  into outer leg . Open side of the wedge
should face the same direction as the open side of the outer leg.
4. Place the roller frame  upside down on a level surface and mount
the leg clips . The clips mount in the top holes of the center cross‑
members as the frame is currently oriented (see Figure 2). This will put
them on the bottom of the frame when the unit is in the upright position.
Use (2) 10‑24 x 1/2" button head bolts and (2) 10‑24 keps nuts.
5. Attach loose leaf leg hinge  to inner leg wedge . Orient so when
the leg is in an upright position (as the leg would be during use) the
unsecured 1/2 of the hinge hangs down. Flat side of hinge should be
toward the wedge. Pin side of the hinge facing out, or away from wedge.
Secure with (4) 10‑24 x 1/2" button head bolts and (4) 10‑24 keps nuts.
Feed the bolts through the hinge first.
6. Fold the leg brace in half and lay the leg assembly onto the roller frame.
Orient so the unsecured 1/2 of the hinge hangs down and inline with the
holes in the roller frame cross‑member. Secure the hinge to the roller
frame with (4) 10‑24 x 1/2" button head bolts and (4) 10‑24 keps nuts.
Figure 3 and Figure 4.
7. Tip the unit onto its side and swing the legs into their vertical position.
Attach the unsecured ends of the leg braces to the center cross‑member
of the roller frame. DO NOT ATTEMPT TO ATTACH THESE WITH THE
FRAME UPSIDE DOWN! The leg could slam into the closed position
causing an injury. Secure with (2) 10‑24 x 1/2" button head bolts and (2)
10‑24 keps nuts. Figure 2.
8. Install the (4) adjustable glides  into the threaded bosses of the legs.
9. Turn the assembled unit upright and install the rollers using the flat blade
of a putty knife like a shoehorn. The spring axles will snap into place.
Folds up quickly
for storage or transport.
3
Figure 1
Leg
Brace
Leg
Clip
Figure 2
Roller
Frame
Hinge
Open Side
of Wedge
Figure 3
Wedge
Hinge
Cross
Member
(Table Shown Upside Down)
Figure 4
Open Side
of Wedge
Leg
Brace
Top of Table
Cross
Member
Roller
Cross
Member
Wedge
Open Side
Roller
of Wedge
Frame
Roller