Idiomas disponibles
Idiomas disponibles
Mode setting
Depending on the intended application, set the mode selector to the respective symbol.
WARNING! Only change the mode when the power tool is switched off and has come to a
complete stop! Always move the selector to its end position, do not the power tool with the selector
in an intermediate position!
Operation
Drilling
1. Adjust the mode selector to the drill symbol.
2. Keep ventilation openings of the power tool free and clean. Do not cover them during operation.
3. Fix small work in a bench vice or with bar clamps.
4. Mark the holes for drilling in metal with a punch. This prevents the drill from slipping.
5. Put a piece of matured timber under the work piece when drilling in wood. This prevents splinte-
ring at the back of the hole.
6. Pay attention to that the rotational speed of the power tool is efficient. Do not expose too high
pressure on it.
Hammer drilling
1. Adjust the mode selector to the hammer symbol.
2. Keep ventilation openings of the power tool free and clean. Do not cover them during operation.
3. Fix small work in a bench vice or with bar clamps.
4. Mark the holes for drilling in metal with a punch. This prevents the drill from slipping.
5. Put a piece of matured timber under the work piece when drilling in wood. This prevents splinte-
ring at the back of the hole.
6. Pay attention to that the rotational speed of the power tool is efficient. Do not expose too high
pressure on it.
Working light
The work light is switched on and off together with the power tool when pressing the on/off switch.
9. MAINTENANCE
Care and cleaning
Keep the ventilation openings clear and clean the product regularly. Clean the housing only with a
damp cloth-do not uses any solvents! Dry thoroughly afterwards.
CAUTION! If something unusual occurs during use, switch off the supply and disconnect the plug.
Inspect and repair the tool before using it again. The repairs must be carried out by a qualified
Position for
hammer drilling
in concrete or
stone.
10
Position for drilling
without impact in wood,
metal, ceramic and
plastic.
