Idiomas disponibles
Idiomas disponibles
2.
Push red hot water release button inward and depress hot water control downward
to start flow.
3.
Release hot water control once desired fill level is achieved.
Replacing an Empty Bottle
Notice: When the bottle icon on the digital screen is blinking, you are either
low on water or the seal between the probe and bottle is not complete.
You may also hear a sucking sound when the bottle empties. This is normal
and is another way to be alerted that your bottle is empty.
Replace empty bottle as soon as you notice it is empty or you see the
blinking bottle icon.
There will be a small amount of water left in the bottle that can not be used.
1.
Open door and slide bottle tray out.
2.
Remove probe from bottle by pulling straight up.
3.
Hang probe on inside of door so it remains clean.
4.
Remove empty bottle from tray and replace it with a fresh one.
5.
Remove tamper seal from cap of fresh bottle.
6.
Clean bottle cap and neck with a soft cloth and warm soapy water, then rinse.
7.
Use tool to apply slight pressure downwards on cap plug until it releases into the
bottle.
8.
Slide probe into bottle. Push lightly down on head to create a tight seal with the
bottle.
9.
Once you are sure you have a complete seal, slide the tray into the cabinet and
close door completely.
PROPER CARE & CLEANING
General Cleaning
Perform: As needed
Time Required: 5 minutes.
Note: Do NOT use abrasive materials or chemical cleaners.
1.
Clean cabinet surfaces with a soft cloth and warm soapy water.
2.
Wipe dust from back of dispenser to improve efficiency.
3.
Remove drip tray assembly by sliding it forward. Remove cover. Place tray and
cover in dishwasher or wipe parts clean with a soft cloth and warm soapy water.
All manuals and user guides at all-guides.com
Model # 900142: Page 9
