Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS MANUAL
CODE 80170
REV D
07/2020
Pag. 20
13. MALFUNCTIONS
You may be able to rectify the following faults by checking the possible causes
yourself:
• Appliance does not function:
– Is the appliance switched on?
– Is the plug correctly fitted in the mains socket?
– Is the fuse intact?
• The temperature is not low enough:
– Is the temperature setting correct (see "Setting the temperature")?
– Have excessive amounts of fresh food been placed in the appliance?
– Does the separately installed thermometer show the correct reading?
– Is the ventilation system working properly?
– Is the appliance set up too close to a heat source?
If none of the above causes apply and you cannot rectify the fault yourself,
contact the technical service department stating the type designation and
serial number as indicated on the type plate.
14. CHANGING OVER DOOR HINGES
Door hinges should only be changed by a trained expert.
Changing the door hinges must be done by two people.
1. Open door by about 90°.
NOTE
The door must be opened 90° before the lower hinge bracket is
removed.
This will hold the self-closing mechanism that is integrated into the door in
the required position for installation.
WARNING!
If the door is removed and reinstalled in the closed position, this
will lead to destruction of the self-closing mechanism on the first
opening of the door.
2. Remove hinge bracket. Pull the door out at the bottom and lift off.
IMPORTANT
As a result of its heavy weight, the door must be held secure by one person.
J
.P. SELECTA s.a.u.
Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España
Tel (34) 93 770 08 77 Fax (34) 93 770 23 62
e-mail: [email protected] - http://www.jpselecta.es
Tabla de contenido
